Drivers Side Rocker job
Fender removed; cleaned up
not too bad!
not too bad!
rocker cut out for inspection
POR15 added to rusty areas
after cleaning and etch
POR15 added to rusty areas
after cleaning and etch
POR15 added to rusty areas
after cleaning and etch
POR15 added to rusty areas
after cleaning and etch
POR15 added to rusty areas
after cleaning and etch
new jacking point installed
patch installed on castle rail
underside of patch
underside of patch
front castle rail patch and floor
patch
looks good!
Cleaned and POR15'ed
another layer of POR15 applied
membrane cleaned and
POR15'ed
membrane cleaned and
POR15'ed
membrane cleaned and
POR15'ed
membrane cleaned and
POR15'ed
membrane cleaned and
POR15'ed
membrane cleaned and
POR15'ed
Outer clamped in place, tacked
in
Outer clamped in place, tacked
in
clamped and tacked
end cap installed
front section
sill tacks
sill tacks
sill tacks
spot welds on front panel
spot welds on front panel
all done (mostly)
Done (mostly)
GT Rocker Panel Job
